Dragon 32 Ram upgrade issue

classic non-acorn hardware, software & languages
Post Reply
axeman
Posts: 22
Joined: Tue Nov 27, 2018 11:02 am
Contact:

Dragon 32 Ram upgrade issue

Post by axeman »

I've attempted the standard upgrade detailed here as I have 8 64bit ram chips
http://archive.worldofdragon.org/index. ... 4K_Upgrade

but I'm getting this screen. Anyone got any ideas what might be wrong.

Tried with ic33 pin 8 GND connected and not connected. Seems strange that these instructions ask to disconnect the gnd pin??
IMG_20200326_114304.jpg
IMG_20200326_114406_1.jpg
Prime
Posts: 2888
Joined: Mon Jun 01, 2009 12:52 am
Contact:

Re: Dragon 32 Ram upgrade issue

Post by Prime »

axeman wrote:
Thu Mar 26, 2020 1:27 pm
I've attempted the standard upgrade detailed here as I have 8 64bit ram chips
http://archive.worldofdragon.org/index. ... 4K_Upgrade

but I'm getting this screen. Anyone got any ideas what might be wrong.

Tried with ic33 pin 8 GND connected and not connected. Seems strange that these instructions ask to disconnect the gnd pin??
No you need to cut the trace between pin 5 and pin 8, wich will disconnect pin 5 from ground. Pin 8 needs to still be connected to ground, check this by beeping it out to another ground pin on another chip.

Is R73 fitted, should be on the right hand side of the rightmost PIA.

Can you post a picture of the RAM area? Is it one of the boards with half good 64s, or a patchboard or 16x16K?

Cheers.

Phill.
axeman
Posts: 22
Joined: Tue Nov 27, 2018 11:02 am
Contact:

Re: Dragon 32 Ram upgrade issue

Post by axeman »

Hi,

Here is a picture of the board

No can't see any R73

Oh and I took all the wiring off to redo it
IMG_20200327_102942.jpg
axeman
Posts: 22
Joined: Tue Nov 27, 2018 11:02 am
Contact:

Re: Dragon 32 Ram upgrade issue

Post by axeman »

Beginning to panic a little as I've replaced with a new ic33 and put back the wiring and still getting the screen shot shown previously. Any ideas?
Prime
Posts: 2888
Joined: Mon Jun 01, 2009 12:52 am
Contact:

Re: Dragon 32 Ram upgrade issue

Post by Prime »

Did you cut the tracks as directed in the upgrade guide, if so have you put those back?

Cheers.

Phill.
axeman
Posts: 22
Joined: Tue Nov 27, 2018 11:02 am
Contact:

Re: Dragon 32 Ram upgrade issue

Post by axeman »

Yes everything is back as was. Going to check continuity on IC31 IC33 pins
Post Reply

Return to “other vintage hardware, software and languages”