Thanks for the info...BeebMaster wrote:I've used IEEEFS0.5 to work with my kit, although to very little avail as you can't do much without an IEEE488 device attached to the adapter.
I seem to recall that there is a mistake in the manual which is corrected in JGH's version - possibly there is a thread on here about this. My last set of pictures of IEEE488 kit are from January 2012, so it could be around that time.
It's an 8K ROM image. A 27128 should be fine, you can also use a 2764 if you have one lying around.Multiwizard wrote:... Must the Eprom be a 27128D rom or another type?...
which I've done with the copies on mdfs.net.NOTE:
The bytes passed in XY+0 and XY+1 must be the length of the whole control
block, including the length bytes. Consequently, the above arg0 and arg1
values must be increased by 2 before being placed in the control block.
Code: Select all
$ bbcbasic
PDP11 BBC BASIC IV Version 0.25
(C) Copyright J.G.Harston 1989,2005-2015
>_