ca65 .list on off

handy tools that can assist in the development of new software
Post Reply
Posts: 41
Joined: Thu Oct 04, 2018 8:40 pm
Location: Northampton

ca65 .list on off

Post by ChrisO » Sat Jan 26, 2019 9:06 pm

I'm using .if .endif to select conditional blocks of code. This does the job but in the listing output the blocks of code that have not been assembled are still shown. I've used .list on/off to switch the listing on for the 'active' blocks only but annoyingly you can see the .list on off instructions in the listing !, is there a way I can stop them appearing ? Or is there a better way to do what I'm trying to do ?

(Please bear with me this is my first go at using control commands with ca65 !)


Post Reply

Return to “development tools”